Sennheiser Set 820 S Bedienungsanleitung Seite 34

Changing the transmission channel
To avoid interference caused by
the simultaneous operation of se-
veral transmitters, select a diffe-
rent channel on each transmitter.
To select a channel, set the
CHANNEL switch at the rear of
the transmitter to the desired po-
sition. Due to restrictions on frequency usage, only two channels are
available:
Position 1 or 3 = channel 1
Position 2 = channel 2
Turning the automatic compression system on
Use the COMP switch (compression) at the rear of the transmitter to turn
the automatic compression system on. This system reproduces soft
passages louder and decreases loud sounds. Choose the setting that
suits your listening preferences.
8