Dismounting the Mixer
The mixer is dismounted in one piece, you are not allowed to disassem-
ble the subassembly.
Prerequisites
The mixer has been flushed with ethanol.
The hole plugs are laid out ready.
Tools
open-end wrench, sizes 1, 4
Allen screwdriver, 2 mm
Process
1. Using the open-end wrench, unfasten the fitting
2. Close the openings with the hole plugs.
3. Using the screwdriver, unfasten the screws
4. Remove the mixer and lay it to the side.
Connect the capillaries, so there is no way for solvent to leak. Afterwards
take the device into operation.
Dismounting the Mixer
Mixer Supplement V6730, version 1.0
.
1
1
2
.
2
5