Whisper Power DDC Kurzleitfaden Seite 5

RESET OF MAINTENANCE TIME
The Digital Diesel Control is equipped with an hour
counter to indicate the time before maintenance. It
will help you to schedule maintenance.
Maintenance time interval
First maintenance:
Next maintenance
IMPORTANT: The maintenance time interval is not
only determined by the number of running hours,
but also by factors like environmental conditions,
average runtime, connected load, etcetera. The
Digital Diesel Control does not take account of
these factors. Refer to the user's manual of your
WhisperPower generator for additional information
about service maintenance to the generator set.
Refer to chapter 8.8 if you want to change the
setting of the maintenance time interval.
Proceed as follows to reset the counter of the
maintenance time after the generator set has been
serviced.
WHISPER XX
STAND BY MODE
Select
3 sec.
SELECT MENU
PRESS SEL
Select
x times
** If "SELECT MENU" cannot be displayed, access to the Select menu is restricted by the installer; see
chapter 2.6
After 50 hrs
Every 150 hrs
Be sure that the
generator set is not
running
Hold Select pressed for 3
seconds until "SELECT
MENU" is displayed**.
Press Select repeatedly
until SERVICE MENU is
shown.
SERVICE MENU
PRESS SET
SERVICE MENU
TO ENTER
Set
CLR MAINT. TIME
PRESS SET 3s
Set
3 sec
CLR MAINT. TIME
DONE
Stop
WHISPER XX
STAND BY MODE
ENGLISH
Then press Set to
enter the Service
menu.
CLR MAINT. TIME is
shown.
To clear the
maintenance time
counter hold Set
pressed for 3 seconds
until DONE is shown.
Then press Stop to
return to the stand-by
menu.
5