Troubleshooting; Storage When Not In Use; Environmental And Disposal Information - Silvercrest SLS 13 A1 Bedienungsanleitung Und Serviceinformationen

The charging process starts as soon as the connection has been established and sufficient sunlight is
available.
You can charge two devices at the same time if the required charging current of both devices does
not exceed 2A in total.
You can interrupt the charging process at any time by disconnecting your device from the solar
panel (A). When your device is fully charged, disconnect it from the solar panel (A).

Troubleshooting

A connected end device is not charged.
 There is not enough sunlight available. Align the solar panel (A) better with respect to the sun.
 If there is no connection to the device, check the connection.
 Your connected device does not comply with the specifications. Check this fact using the
operating instructions of your device.

Storage when not in use

If you will not be using the solar panel (A) for a prolonged period, fold it up and close it with the
Velcro fastener (4). Store the device in a dry, cool location.

Environmental and disposal information

When this symbol appears on a product, this indicates that the product is subject to
the European Directive 2012/19/EU. All old electrical and electronic devices
must be separated from normal household waste and disposed of at designated
state facilities. The correct disposal of old devices in this manner will prevent
environmental pollution and human health hazards. For further information about
proper disposal, contact your local authorities, waste disposal office or the shop
where you bought the device.
Dispose of the packaging in an environmentally compatible manner. Cardboard can be put out for
municipal paper collections or brought to public collection points for recycling. Films and plastic
used for packaging the device are collected by your local disposal services and disposed of in an
environmentally compatible manner.
SilverCrest SLS 13 A1
English - 9