Miele 10 459 520 Montageanweisung Seite 28

en - Installing in a side-by-side combination
 Press the long piece of stainless steel
trim  into the gap at the front
between the two appliances. Make
sure that it sits above connecting
bracket .
Tip: Pressing both ridges along the trim
together as you do so makes it easier to
fit the trim into the gap.
 Carefully work the stainless steel trim
 into the gap. Use a soft cloth to do
this to avoid denting the trim.
 Carefully remove the protective foil
from the stainless steel trim.
 Press the top edge of the short trim
 into the gap. When doing so make
sure that the front edge of the trim is
flush with the edge of connecting
plate .
28
 Fit cover  in between the two con-
trol panels. Make sure that the out-
side edges of the cover are flush with
the control panels. The cover is ad-
justable for this purpose.
 Fit cover  from above onto the con-
necting bracket at the bottom of the
appliances at the front.
 Connect both appliances to the elec-
tricity supply as described in their op-
erating instruction manuals under
"Electrical connection".
 Appliances with ice cube maker:
plumb the appliance into the water
supply as described in the appli-
ance's operating instruction manual.

Warning! Danger of damage
when moving the appliance combin-
ation.
The weight of both appliances when
combined is very heavy. Incorrect
moving can cause dents!
Please observe the instructions on
how to move it.
 The side-by-side combination must
be pushed very carefully into posi-
tion.