Team M 21 Gebrauchsanleitung Seite 13

Fax +32 2 359 95 50


The beaters can be mounted equally in both openings, but for the dough hooks, you have to
respect the sense indicated in page 5 (the hook fitted with a disk has to be placed in the opening
marked with a large circle).

Press the ejection button to remove the accessories.
USE OF THE STICK ATTACHMENT
With this accessory you can mix food as for example vegetables to prepare soups but also to mix
liquids. It only has to be used in a vertical position with blades facing downwards.

Make sure the speed switch is in OFF position and the appliance is unplugged from the power
supply.

Do not forget to remove the other accessories from the appliance.

Slide the protection valve on the backside of the appliance. Then you will see the opening for the
stick attachment.

Insert the stick attachment in the opening so that both shafts, the one on the appliance and the
other one on the stick attachment are facing each other. Turn the stick attachment from a quarter
of revolution clockwise until it stops. Check the locking by pulling on the stick attachment.

To disassemble the stick attachment, proceed inversely and close the protection valve.

Attention, the blades of the stick attachment are very sharp, pay attention not to get cut when
cleaning them.
USE OF THE CHOPPER
With this accessory you can chop condiments, dried fruits or meat. To chop meat, it is recommended
to cut it into small pieces first.

Beforehand assemble the chopper. Therefore place the blades holder on the axle of the bowl and
assemble the lid. The shaft on the lower side has to be facing the one of the bowl, then turn it
clockwise until it stops. It is possible that the lid assembles itself bad, then you only have to turn
lightly the blades holder in order that it inserts itself on the lid correctly. Check the locking of the
lid by pulling on it lightly.

Make sure the speed switch is in OFF position and the appliance is unplugged from the power
supply.

Do not forget to remove the other accessories from the appliance.

Slide the protection valve on the backside of the appliance. Then you will see the opening for the
chopper.

Insert the chopper in the opening so that both shafts, the one on the appliance and the other one
on its lid are facing each other. Turn the chopper from a quarter of revolution clockwise until it
stops. Check the locking by pulling on it lightly.

It is necessary to hold the appliance by its handle when in use.

To remove the chopper, proceed inversely and close the protection valve.

Attention, the blades of the chopper are very sharp, pay attention not to get cut when cleaning it.
USE OF THE WHISK
This accessory completes the beaters because it allows to make preparations in smaller containers.

In order to assemble the whisk, you have to assemble its setting ring on the appliance first.

Make sure the speed switch is in OFF position and the appliance is unplugged from the power
supply.

Do not forget to remove the other accessories from the appliance.
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International
BELGIUM. The page must reproduced and folded in order to
obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).
The page must be folded in order to keep the good numbering
when you turn the page of the I/B . Don't change the page
numbering. Keep the languages integrity.
Assembly page 13/24
13