How To Clean - Team BL 7 Gebrauchsanleitung

Fax +32 2 359 95 50

Do not touch the blades while the appliance is operating and do not try to block their

movement in any way.
Competent qualified electrician: after sales department of the producer or importer or any
(*)
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
IMPORTANT INFORMATION
This appliance is not for professional use. You should follow the requested breaks. Failure to
follow this instruction carefully may result in damage to the motor. Please refer to the rating
label for the maximum continuous usage time (KB xx min where xx is the maximum usage time).
The breaks should last at least 10 minutes.
CAUTION!
Your appliance is fitted with a security device on the pouring jug allowing the functioning of
the appliance only when the jug and its lid are correctly placed on the motor base. If those
conditions are met and the appliance does not start, call your after sales service.
MOUNTING OF THE BLENDER AND USE
If the blade is disassembled from the bottom of the jar, check the cleaning section for
mounting instructions before continuing.
 Assemble the pouring jug on the motor block by turning it from a quarter run anticlockwise
until it stops. To check if it has been done correctly, it should be possible to raise the motor
block with de handle of the pouring jug.
 Fill the pouring jug with the chosen ingredients.
 Screw the lid until it stops making sure that the openings face the pouring lip of the jug.
Those openings serve as filters allowing you to pour only the liquid of your preparation. If it
is too thick, you have to remove the lid in order to serve you.
 Plug in.
 Select the speed that is most suitable for the ingredients you want to process.
 The button "P" (Pulse) allows a manual operation because you have to keep pushing it
when functioning. This position is generally used to crush ice.
 Press button 1 (minimal speed) for mainly liquid ingredients.
 Press button 2 (medium speed) for combinations of liquid and solid ingredients.
 Press button H (maximum speed) for mainly solid ingredients.
 It is also possible to add liquids or other ingredients at each time without stopping the
appliance. You only have to remove the stopper, which closes the lid opening by turning
and raising it straight up.
 Once you have finished the preparation, stop the appliance (button 0) and unplug the
appliance.

HOW TO CLEAN

 Always unplug from outlet before cleaning.
 For a quick rinsing of the pouring jug (for example between two preparations), you can
use clear water and switch on your appliance for a few seconds. In this case, do not use
any detergent.
 For a full cleaning of the pouring jug, remove it from the motor block and turn the blades
support by the jug bottom anti clockwise to disassemble it (this will make the cleaning
easier). Then you can clean the all with soapy water and rinse thoroughly with clear water.
Dry before assembling. Therefore you only have to screw the blades support by turning it
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/28
TEAM BL 7 - 070420