Operating Determinations - EuroLite Foam 1200 Bedienungsanleitung

This device falls under protection-class I. The power plug must only be plugged into a protection class I
outlet.
Always plug in the power plug last. Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections with the mains with particular caution! Make sure that the available voltage is
not higher than stated on the rear panel. Make sure that the power cord is never crimped or damaged by
sharp edges. Check the device and the power cord from time to time.
In case of swallowing or direct contact of the fluid with the skin or eyes make sure to comply with the
instructions in the respective safety data sheet!
DANGER TO LIFE!
- Danger of suffocation for people or animals lying under the foam.
- Maintain sufficient sight in all directions.
- When operating the device, a sufficient number of safety personnel has to be present for supervising the
foam area so that any „disappearing" person will immediately be noticed. If in doubt, the safety personnel
have to limit the number of persons in the foam. The safety personnel must also verify that only such
persons who are fully clear are allowed into the foam.
- After switching off the foam machine, the safety personnel must remain in the foam area, until the foam has
completely disintegrated.
- There must be no obstacles in the foam area.
- The floor surface must be sufficiently anti-slippery. After the foam has disintegrated, the safety personnel
must verify that the floor surface is completely dry and not slippery.
Make sure that the device is installed in an upright position. For overhead use (mounting height > 100 cm),
always secure the fixture appropriately.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord. Unused machines must be disconnected
from the mains. If the power plug or the power switch is not accessible, the device must be disconnected via
the mains.
Keep away children and amateurs! Never leave this device running unattended.

OPERATING DETERMINATIONS

This device is a special effect machine for creating foam effects.
This product is only allowed to be operated with an alternating voltage of 230 V, 50 Hz and was designed for
indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device. When choosing the
installation spot, please make sure that the device is not exposed to extreme heat, moisture or dust. Please
consider that liquid may be spilt during operation around the device. The resulting slippery surface can cause
accidents. There should not be any cables lying around. You endanger your own safety and the safety of
others!
Before filling the device disconnect from mains. Never fill in any hot liquids.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Store dry!
Whenever you transport the product, disengage the tubes leading to and from the pump as well as the
cannon. Also make sure to use the original packaging in order to avoid damage during transportation.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
9/12 00119834, Version 1.3