Setup; System Setup - Kenwood KTC-D500E Bedienungsanleitung

Setup

Setting this unit's behavior and clock.

System Setup

Set the behavior of this unit such as the display
language and aspect ratio.
The following items can be set:
OSD Language User could select the desired language.
This function provides 4:3 and 16:9 two ratio
for user to select. If your display supports 16:9
TV Aspect Ratio
screen format and selected channel provides
16:9 format program, select 16:9.
There are four screen format could be selected,
TV Screen Format
Full, Pan&Scan, Letter Box, and Combined.
User could set the auto switching interval time
from OFF to 30 Seconds when the box cannot
Auto Switching
receive the video signal. User also could use the
Interval
[A] to [Z] key on the RCU to switch the signal
immediately.
Select the TV signal type (PAL or NTSC)
TV Type
according to the display.
Set "0/5 Volt" ON when connecting an antenna
0/5 Volt
with booster amplifier to this unit.
This function provide user to select the unit at a
power on mode or a stand by mode. If the user
Power On Option select the unit at power on mode, when user
turn on the car, then the unit will be turned on
at the same time.
If user connect to an amplifier, user could use
Volume Rate Control the volume rate to control the volume. There
are 18 levels could be selected.
⁄
• Depending on the country where you buy your receiver,
some functions might not be available in this menu.
• If you changed the "0/5 Volt" setting, perform Auto Scan.
1 Show DVB Menu by pressing [MENU] key
2 Touch [5] or [∞], select [Setup]
3 Touch [3]
4 Touch [5] or [∞], select [System Setting]
5 Touch [Enter] ( )
System Setup Menu appears.
6 Touch [5] or [∞] to select the item to set
7 Touch [2] or [3] to select the value to set
8 Touch [Return] ( ) when you are finished
English
13