Replacing Cord Cover - peerless-AV XTREME series Bedienungsanleitung

Replacing Cord Cover

1. Run power and signal cords through notches. To prevent unwanted interference, route the power
cord through the left most notch (see image 1 below).
2. Place the cord cover over the cords being careful not to pinch any of the cords. Loosely install
(6) M5 hex cap screws then tighten screws on the cord cover using 4mm allen wrench (C) until
the gasket on the cover is fully compressed to the cord gasket .
3. Replace the rear cover plate ensuring that the cords are running through the notches on the
display and not getting pinched. Fasten the (2) hex screws on the rear cover plate to secure it in
place using 4mm allen wrench (C). Ensure that rear cover plate is fully compressed to the back
of the display.
1
power cord notch
4 3
• Ensure cord bend radius does not exceed limits set by the
manufacturer.
• Ensure cords are seated properly in the cable channels to avoid
potential damage to cords when rear cover plate is installed.
• Do not remove lanyard that connects the rear cover plate to the display.
• Ensure cables exiting input compartment are routed downward when
installing display in portrait orientation. If the installation requires the
cabling to be routed upward, ensure that the cables are routed with a
drip loop.
CAUTION
12
2
CAUTION
Failure to follow these instructions can result
in the product being damaged or destroyed,
voiding the warranty.
Do not overtighten screws
2018-08-10
M5 hex cap screw
#:180-9120-2 (2019-01-10)