Standards, Certifications And Symbols; Faqs And Solutions; Copyright - Punkt UC 01 Kurzanleitung

English - UC 01 Quick Guide

Standards, certifications and symbols

UL / cUL combined compliance for products tested
and approved for the US and Canadian markets.
I.T.E. POWER SUPPLY
E471731
"CE" conformity mark. This is the declaration that
the product meets the requirements of the
applicable EC directives.
This symbol indicates that the product has Class II
electrical insulation.
This symbol indicates that the product is only for
domestic use.
Separate collection of electrical and electronic
equipment. This indicates that the product must be
disposed of separately to prevent pollution.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operations.
6

FAQs and Solutions

1. Which of the 3 ports should I use to charge my device?
Any port can be used to charge any device (within the available
amperage).
2. The UC 01 is not charging my device, what should I do?
Please make sure that your device is USB powered and that the
required input current is under 2.5A.
Check that your UC 01 is firmly connected to the power cable
and the power cable is securely plugged into an active wall
socket. Also make sure that the device attached to the UC 01 is
properly connected at both ends.
If your device is still not charging, disconnect all the devices
from the UC 01 and the UC 01 from the power cable then reconnect.
3. How can I find out the input voltage and input current of
my device?
This information can be found in the user manual for your
device, or on the original charging adapter. Otherwise please
contact the manufacturer of the device.
4. The input current of my device is 1A, could the UC 01
damage my device?
No, the UC 01 only supplies the current your device requires,
but only up to 2.5A.

Copyright

© 2015 Punkt. Tronics AG.
All rights reserved.
Punkt. and the Punkt. logo
are registered trademarks
of Punkt. Tronics AG.
UC 01 is a registered design.
Made in Italy.
7