VINCENT STU-1 Bedienungsanleitung Seite 33

Operation
Select a radio station by
inputting its radio
frequency numerically
Change to playback
from a preset station
Storing stations (Presets)
Mute the Volume during
frequency search
OPERATING THE APPLIANCE
Button(s) Description
To input a known station frequency directly, you can proceed as follows:
DIRECT
Press the "DIRECT" button. The tuner waits for an entry using the numerical
(11)(18) keys in the next few seconds. In FM mode, 4 or 5 numbers need to be
entered, two of which come after the decimal point of the frequency in
Number keys
MHz. For a FM frequency below 100MHz you need not enter the leading
(3)(22) Zero „0". If an invalid frequency is entered, the appliance corrects this to
the nearest valid frequency.
You are able to store up to 30 radio frequencies for each of the frequency
bands (FM, AM) and select them using their positions in the memory. If sta-
TUNING tions have already been stored, one of them can now be selected by ente-
MODE ring the position in the memory with the numerical keys. If a single digit sta-
(5)(21) tion number (1-9) needs to be selected, it can be entered by pressing a
corresponding button. In case of a two-digit station number, the button "0"
Number keys should be pressed as many times as the corresponding tens. If the second
(3)(22) digit of the station number is zero, then no additional keystroke is needed.
If the second digit is a number between 1-9, then the units should be ente-
TUNING red with the corresponding buttons 1-9. Example: For station number 22,
PRESET "0" is pressed twice, and after that "2" is pressed once. To search through
UP/DOWN all the stations stored, the "TUNING MODE" button can be used to select
(10)(25) the option "PRESET" (search through all stations stored). Using the buttons
"TUNING PRESET" it is now possible to go through all the positions alrea-
dy stored.
To store a new preset in memory, select the radio frequency as already descri-
bed. Then press "MEMORY" followed by a two-digit number from the numeri-
cal keypad to set the required position (1 to 30). The setting only becomes
effective by pressing "MEMORY" again. The station number in such a case is
MEMORY entered in the following way: If a single digit station number (1-9) needs to be
(9)(23) selected, it can be entered by a corresponding keystroke. With two digit stati-
on number, the button "0" button should be pressed as many times as the cor-
Number keys responding tens. If the second digit of the station number is zero, then no addi-
(3)(22) tional keystroke is needed. If the second digit is a number between 1-9, then
the units should be entered with the corresponding buttons 1-9. Example: For
station number 22, "0" is pressed twice, and after that "2" is pressed once.
30 station presets are available for each of the frequency bands (AM and
FM), respectively.
A volume mute function during manual frequency search ("AUTOSCAN"
AUTO MUTE tuning mode is active) can be switched on and off with this button. It cuts
(19) out interference between the station frequencies. This function is only availa-
ble using the remote control.
Vincent
33