Setting the functions
Turn on the DVR and press Menu Button under Video mode or Camera mode to enter into setting
interface. Confirm by OK Button and select by Up/Down Button for the following setting. Press Menu
Button again to exit after finished.
A. Video mode
1. Resolution: Select 1080P/720P/VGA
2. Time Stamp: Select Off/On
3. Motion Detection: Select Off/On
Note: In "Motion Detect" mode, it will begin recording automatically on detecting motion
and will stop recording when there's no movement around.
4. Video Time: Select Off/1 Min/3 Min/5 Min/10 Min to determine length of each run that
should be stored.
5. Voice Record: Select On/Off
6. EV: Select +2.0, +5/3, +4/3, +1.0, +2/3, +1/3, +0.0, -1/3, -2/3, -1.0, -4/3, -5/3, -2.0 Use this
setting to adjust for varying lighting conditions, usually, +0.0 is suitable for most
environments.
B. Camera mode
1. Size: 3M/2M/1.3M/VGA
2. EV: Select +2.0, +5/3, +4/3, +1.0, +2/3, +1/3, +0.0, -1/3, -2/3, -1.0, -4/3, -5/3, -2.0 Use this
setting to adjust for varying lighting conditions, usually, +0.0 is suitable for most
environments.
C. Setting Mode:
Whenever under Video mode or capture mode, press Menu Button twice to enter
interface.
1. Format: Select it if you want to format the Micro SD (TF) card
2. Language: Select English/Traditional Chinese/Simplified
Chinese/Japanese/Francais/Deutsch/.../Italiano/Portuguese/.../Espanol/...etc (12 languages)
3. Auto Off: select Off/1 Min/3 Min/5 Min
4. LCD Off: Set the Dash Cam to switch off the LCD display(off/1 Min/3 Min /5 Min).The default
setting is "off".
5. System Reset: Select Cancel/Execute system reset
6. Light Frequency: Set 50/60Hz
7. Date Input: Set correct recording Date and time by OK Button and Up/Down Button
8. LED: Setting Off/On/Auto
9. USB: PC Cam/Disk Drive
10. version
5
into
Setup