AXTON CAC215 Einbauanleitung Seite 8

CAC215 CAC218 Manual RZ
OPTION 3 (flush mounting)
1) Remove the panel you are going to
install the tweeter, to check for proper
clearance behind it. The flush mount kit
is 24 mm deep, so make sure there are
no obstructions behind the spot you
choose.
2) Mark the center of the spot and cut a
hole with a diameter of 47 mm, for ex-
ample using a hole-saw attachment for
your power drill.
3) Install the flush mount cup in the hole
and secure it by using the spring clips
included in the hardware set.
1c
07.01.2003 9:06 Uhr
4) Run the speaker wire included in the
5) Mount the main tweeter unit to the flush
7
6
5
1
4
3
2
– 8 –
Seite 8
speaker wire kit from the crossover to the
installed flush adapter base. Connect the
tweeter wire to the wire extension
coming from the crossover.
mount base by inserting the tweeter into
the base (onto the spring) and turning the
tweeter fascia ring on top counter-clock-
wise. This locks the ring in place. You
can now pinpoint the tweeter into the
desired direction.
See figure 1c below, for closer
reference.
1