General Warnings - Haverland RC-E Montageanleitung Und Bedienungsanleitung

WE THANK YOU FOR PURCHASING A HAVERLAND THERMAL TRANSMITTER.
PLEASE READ THESE INSTRUCTIONS BEFORE STARTING THIS APPLIANCE.
THESE INSTRUCTIONS SHOULD BE KEPT FOR FUTURE REFERENCE AND SHOULD BE GIVEN TO
ANY NEW USER.
BEFORE CONNECTING THE APPLIANCE MAKE SURE THAT IT'S VOLTAGE (230 V – 50 HZ)
COINCIDES WITH THE VOLTAGE OF THE POWER SUPPLY WHERE IT IS GOING TO BE CONNECTED.
THE APPLIANCE SHOULD NOT BE USED IN PRESENCE OF GASES, EXPLOSIVES OR
INFLAMMBLE OBJECTS.

GENERAL WARNINGS

This thermal transmitter is an appliance to be fixed to the wall. Please read the explicatory
instructions for its assemblage.
This transmitter has been filled with determined quantity of special thermal fluid. For this reason
the necessary reparations that need the opening of the deposit or presence of any kind of escape
should be undertaken by the manufacturer or by its Technical Assistance Service.
Never pull the wire.
Do not leave the connection wire in contact with the appliance while it is On.
During its functioning, one must be careful to maintain the appliance far from combustible
material such as curtains, carpets furniture etc.
DO NOT COVER THE APPLIANCE. DO NOT USE IT TO DRY CLOTHES. If it is covered there is an
overheating risk.
In order to prevent children from modifying the thermal transmitter programming, a safety
blocking function is incorporated. To enter the programming mode the "Prog" key must be pressed
for at least one and a half seconds.
If the power supply cable is damaged, it should be substituted by another one provided by the
manufacturer or its Technical Assistance Service.
If the appliance is going to be installed in the bathroom, it should be put in such a way that
nobody in the bathtub or shower should be able to touch it (Fig. 6).
The appliance should not be located under or in front of a power supply socket.
In order to disconnect the thermal transmitter from the mains power supply, unplug from the
wall socket.
Ensure that the thermal transmitter has been unplugged from the wall socket before carrying
out any operation inside.
At the moment of getting rid of these transmitters, the established rules for their treatment and
recycling should be kept into account (thermal fluid).
The installation should be undertaken according to the correct rules regarding the electric
installation.
All the models come with a safety thermostat. This will disconnect the appliance if it gets
overheated for any reason. IMPORTANT: TO REINSTALL THE APPLIANCE THE TRANSMITTER PLUG
SHOULD BE DISCONNECTED FROM THE POWER SUPPLY AND WAIT FOR A 4 MINUTES BEFORE
CONNECTING IT AGAIN.
The appliance should have a ground connection.
The appliance should be installed in such a way that the power supply plug should always be
accessible.
This transmitter should not be fitted in. Please respect the safety distance (Fig. 4).
The guarantee of the appliance will not cover any damage caused by not reading and following
carefully these instructions.
This appliance is not intended for use by persons (including children) withreduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instructionconcerning use of appliance by a person responsible for their safety.Children should be
supervised to ensure that they do not play with the appliance.
30