Safety Information - thomann Harley Benton PowerPlant Bedienungsanleitung

Safety information

For your own safety you should first read this chapter completely.
Risk of electrical shocks!
• Connect the device exclusively to a properly wired and earthed
electrical wall socket with a mains voltage of 230 V~ / 50 Hz.
Never cut the earth wire of the mains cable.
• Do not operate the device if the mains cable or the power plug is
damaged.
• Never submerse the device in water. Wipe it only with a slightly
damp cloth.
• Do not expose the device to rain and never use it in a damp or
wet environment.
• Do not expose the device to high temperature, direct sunlight or
excessive dust.
• Make sure that the power cord does not become wet during
operation.
• Before checking the fuse that's integrated in the units mains
socket, you must disconnect the device from the mains!
• Make sure that the power cord does not become wet during
operation.
• You must not open the device housing or repair the device. In
this case safety is not assured and the warranty will become
void. There are no user serviceable parts inside, only high
voltage able to kill you!
• Do not place objects containing fluids, e.g. flower vases or
glasses on or near the device.
• Notice regarding power disconnection:
To completely disconnect the device from the power source
the power plug must be removed from the power socket. For
this reason the device should be placed in a position where a
constant unobstructed access to the power socket is assured,
thus in an emergency situation you are able to immediately
pull out the power plug. To eliminate the risk of fire you should
completely disconnect the power plug from the power socket
when the device is not going to be used.
10