Attachments; Interface And Outputs - IKA KS 3000 i control Betriebsanleitung

Attachments

The following attachments are offered as accessories
AS 260.1
Universal attachment
The attachments are a xed to the shaking table using the four clamping screws provided.
Load (standard values)
Load / kg
Max. speed / rpm
Interfaces and outputs
USB interface
The Universal Serial Bus (USB) is a serial bus system for connec-
ting the KS 3000 to the PC. Devices with USB capabilities can be
connected and disconnected whilst in operation (hot-plugging);
connected devices and their properties are also detected automa-
tically.
The USB interface is used in conjunction with labworldsoft
operation in "Remote" mode
Installation
Connect the KS 3000 to the PC using the USB data cable. The KS
3000 will then transmit information to the Windows operating
system to tell it which device drivers are required. Windows will
then either:
- Load the driver
- Install the driver automatically, if it is not already installed
- Prompt the user to perform a manual installation
- In this case, select the appropriate download from the IKA
Internet product page.
Configuration
The unit can be controlled from an external PC (using the dedica-
ted software labworldsoft) via the RS 232 C serial interface / USB
fitted to the unit.
To increase safety when controlling the shaking unit from
a PC, enable the watchdog function for monitoring the
continuous serial data flow (see section watchdog function)
ment and automation system are selected from the specfied
signals of the EIA-standard RS 232 C, corresponding with DIN
66020 Part 1. The allotment of the bushing can be taken from
illustration.
allotment of the signal status, standard RS 232 C, correspon-
ding with DIN 66259 Part 1 applies.
AS 260.2
Bracket attachment
1 3 5
500 400 300
for
®
Instruction syntax
Here applies thje following:
to the laboratory instrument (slave).
processor. Even error codes cannot be spontaneously communi-
cated from the laboratory instrument to the processor (automa-
tic system)
are separated by at least o n e blank. (Code: hex 0x20)
well as each reply are terminated with CR LF (Code: hex
0x0D and 0x0A) and have a maximum lenght of 80 characters.
(Code: hex 0x2E)
The above statements largely correspond with the recommenda-
tions of the NAMUR-Assocation (NAMUR-recommendations for
the design of electric plug connections for the analog and digital
signal transmission to labortory - MSR individual units. Rev. 1.1).
AS 260.3
Bowl attachment Separating funnel attachment
7,5
120
on in start-stop-operation.
format DIN 66022 for start –
stop operation. 1 start bit;
7 character bits; 1 parity bit-
[straight (even)]; 1 stop bit..
ker to computer is only possible
on demand of the computer.
AS 260.5
20