Specification - Optimum SW-1018 Gebrauchsanweisung

24. D uring operation the hair straightener becomes hot. Do not
place it near flammable materials.
25. A llow the hair straightener to cool before putting it away.
Allow to cool before storing.
26. D o not use the appliance with a voltage converter.
27. D o not direct hot air toward eyes, hands or other heat-
sensitive areas.
28. D o not unplug by pulling on cord. To unplug grasp the
plug.
29. R isks exist even if the hair straightener is switched off.
Always unplug the appliance from the electrical outlet
immediately after using and before cleaning.
30. D o not wrap the cord around the appliance (risk of breaking
the cord).
31. D o not cover the hair straightener as it might cause heat
accumulating inside of it.
32. I n case of handing over the appliance to another person
please inform that person about these instructions for use.
33. A ttachments may be hot during and after use. Allow them
to cool before handling.
34. Do not use attachments that are not recommended.
35. A lways unplug the hair straightener from the electrical
outlet after use.
36. I f the hair straightener is used in the bathroom, always
unplug it from the electrical outlet after use, as it may pose
a risk even when the appliance is switched off.
37. F or additional safety it is recommended to install an RCD
device in the electric circuit supplying the sockets with
a maximum rated residual current of 30mA. For more
information please consult a qualified electrician.
Description
1. LED Display
2. Switch setting
3. Spin lock cover
4. Styling plates
5. Swivel cord
•. I ndividual temperature choice: Using the temperature
selection switch (2), you can adjust the temperature in a
range between 1 or 2 (1=160°C low setting / 2=220°C high
setting).
Hair structure
Fine, porous, coloured, bleached
Strong, resistant
. . . and for professional styling results
The higher the temperature setting, the faster you will get .
a sleek straightening result. When working with the maximum
temperature setting, you should not treat the same strand more
than once.
•. .Express h eat up time: After only 60 seconds, the appliance
is ready for use.
SW1018_IM_204.indd 7
Getting started
1. Insert the mains plug into the wall socket.
2. S witch the appliance on by setting the temperature selection
switch (2) to 1 or 2 (1=160°C / 2=220°C).
Styling
Preparation
• M ake sure your hair is completely dry before using the
appliance.
• F irst, comb your hair through with a wide toothed comb to
remove tangles.
• S ection your hair off. Starting close to the roots, take a thin
section of hair (strands of 3–4 cm maximum) and clamp it
firmly between the styling plates.
How to straighten your hair
• G ently run the straightener through the entire length of the
hair, slowly and steadily, from roots to the ends without
stopping for longer than 2 seconds. This will ensure best
straightening results without damaging your hair. The
styling plates (4) ensure easy and smooth gliding.
• Y ou can create flicks at the hair ends by slowly turning the
appliance either outwards or inwards before releasing a
strand.
How to form curls
You can also create loose curls and waves:
• C lamp a strand at the roots,
• t urn the appliance half a turn,
• t hen slowly move the appliance horizontally towards hair
ends and the strand will turn into curl.
After use
After each use, switch off the appliance by pushing the button
back to "0" setting.
Cleaning
Always unplug before cleaning. Never immerse the appliance
in water. Clean the appliance with a damp cloth and use a soft
cloth to dry.
Subject to change without notice.
This product conforms to the European Directives EMC
Temperature
89/336/EEC and Low Voltage 2006/95/EC.
setting
160 C
0

SPECIFICATION:

Power supply: 220-240V ~ 50Hz
220 C
0
Power consumption: 40W
Ecology – Environmental Protection
The "crossed-out trash bin" symbol on electrical
equipment or packaging indicates that the device
cannot be treated as general household waste and
should not be disposed of into containers for such waste.
Obsolete or broken-down electrical device should be .
delivered to special designated collection points, organized by

2010-12-28...15:31:34