Unitekno A20 series Benutzer- Und Wartungshandbuch Seite 17

CONTROL A TABLE 900
A. Table on/off switch B. Steam generator on/off switch C.
Dial to switch from aspiration mode to soft blow mode
D. Steam control lighto E. Warning light for missing water
CONTROL A TABLE 900 PLUS
A. Table on/off switch D. Steam control light
E. Warning light for missing water
Before ironing, check the type of fabric and set your iron accordingly. Always start ironing fabrics which require
lower temperatures. Use either normal tap water or demineralised water. Do not use detergents or any other
substances to clean the device Follow the guidelines on the MAINTENANCE chapter of this manual.
USE
OPENING AND CLOSING
To open, bring in a vertical position;
the function panel should face
downwards. Press the handle 4
towards the body of the board and
rotate it 90 degrees, while the legs
unfold. To close the board push
handle 4 towards the body of the
board and rotate it 90 degrees,
while the legs fold up.
16
CONTROL A TABLE 950
A. Table on/off switch B. Steam generator on/off switch C.
Dial to switch from aspiration mode
to soft blow mode D. Steam control light E. Warning light for
missing water
CONTROL A TABLE 950 PLUS
A. Table on/off switch C. Dial to switch from aspiration mode
to soft blow mode D. Steam control light E. Warning light for
missing water F. Iron switch
STORAGE POSITION
After use store the board in a
vertical position, function panel
facing down. It is possible than
some water condensation remains
inside and that some drops
of water will exit through the
appropriate condensation holes.
Never place the board in a way that
the pointed end faces down. The
electric cable and pedal can be
placed on the fitted shelf area (9).
USE OF THE STEAM GENERATOR
Connecting the iron
Attach the connector as follows:
Hook the socket flap on to the
lower hook of the connector.
Pull the flap well open.
Insert the connector into the socket
until it clicks into place.
Press the button to unlock and
extract the connector.