General Instructions - HELIX P SIX DSP Handbuch

Congratulations!
Dear Customer,
Congratulations on your purchase of this innovative
and high-qual ity HELIX product.
With the HELIX P SIX DSP, Audiotec Fischer is set-
ting new standards in the range of digital amplifiers.

General instructions

General installation instructions for HELIX
components
To prevent damage to the unit and possible injury,
read this manual carefully and follow all installation
instructions. This product has been checked for
proper function prior to shipping and is guaranteed
against manufacturing defects.
Before starting your installation, disconnect
the battery's negative terminal to prevent
damage to the unit, fire and / or risk of injury. For
a proper performance and to ensure full warranty
coverage, we strongly recommend to get this prod-
uct installed by an authorized HELIX dealer.
Install your HELIX P SIX DSP in a dry location
with sufficient air circulation for proper cooling of
the equipment. The amplifier should be secured
to a solid mounting surface using proper mount-
ing hardware. Before mounting, carefully examine
the area around and behind the proposed instal-
lation location to insure that there are no electrical
cables or components, hydraulic brake lines or any
part of the fuel tank located behind the mounting
surface. Failure to do so may result in unpredictable
damage to these components and possible costly
repairs to the vehicle.
We wish you many hours of enjoyment with your
new HELIX P SIX DSP.
Yours,
AUDIOTEC FISCHER
General instruction for connecting the HELIX
P SIX DSP amplifier
The HELIX P SIX DSP amplifier may only be in-
stalled in motor vehicles which have a 12 Volt neg-
ative terminal connected to the chassis ground. Any
other system could cause damage to the amplifier
and the electrical system of the vehicle. The posi-
tive cable from the battery for the complete system
should be provided with a main fuse at a distance of
max. 30 cm from the battery. The value of the fuse
is calculated from the maximum total current input
of the car audio system.
Use only suitable cables with sufficient ca-
ble cross-section for the connection of HELIX
P SIX DSP. The fuses may only be replaced by
identically rated fuses (3 x 25 A) to avoid dam-
age of the amplifier.
Prior to installation, plan the wire routing to
avoid any possible damage to the wire harness.
All cabling should be protected against possible
crushing or pinching hazards. Also avoid routing
cables close to potential noise sources such as
electric motors, high power accessories and other
vehicle harnesses.
15