Werbung
Verfügbare Sprachen
Verfügbare Sprachen
24185 Speaker wall mount
- adjustable to any angle by special swivel joint assembly
SAFETY INSTRUCTIONS
- Max.load: 8 kg
- For indoor use only
- Choose a position and mounting method compliant with
-
local building codes and regulations
- Use four anchors per wall bracket
- For use only by trained installers
- Only for use at proper walls with adequate anchors
-
(see B; not included in delivery)
- Not suitable for fragile walls. Beware of power suplly lines
-
and water conduits. In case ask an expert.
- Inspect bolted assemblies regularly.
- Keep the grub screw 4 tightened; only loosen the
-
screws while adjusting the speaker
-
NOTE: before adjusting hold the speaker safe from tilting over;
-
in case, two people should perform this task
- Check speaker threads to ensure attachment screws
-
are not cross threaded
MANUAL
Please check to ensure you have all of the following
components:
1 speaker plate with swivel joint
2 wallplate with tube
3 swivel joint
4 grub screw M6x8
5 wing screw M6x15
ATTACH WALL PLATE TO THE WALL
B
1. Find a location on the wall
1.
where you wish to mount the wall
1.
plate, ensuring that it is vertical.
2. Mark the drill holes.
BRACKET MOUNTING
D
For easier mounting of the speaker adjust speaker plate 1 in
a way that the four holes are lateral from the swivel joint 3
C
3. Drill the holes for the
2. a. For installation into stone or masonary walls, use an appropriate wall anchor (not supplied).
3.
wall plugs, 4x
2.
3.
-ø 6 for anchor bolts
2. b.
3.
-ø 8 for dowels
2. b.
concrete wall
HOLE PATTERNS
A
speaker plate
b. For installation on a wood or plaster wall, it is recommended that the wall adapter be attached
to a supporting wall stud, or other suitable support. The two Center holes in the wall plate can
be used for a stud wall installation.
perforated bricks
E
speaker
screw
not incl.
allen
wrench
AF3
not incl.
wall plate
wood wall
Push swivel joint 3
over the tube
Tighten grub screw 4 with allen
wrench and wing screw 5 by hand
Werbung
