Switching On And Off - Toolland VL102 Bedienungsanleitung

 Never block the air intake of the device.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 This device is not intended for professional use.
 This device serves exclusively to eliminate sprawl between paving stones, on paved areas, from masonry,
in flower beds and lawns during the growth period.
 You can also use the device for lighting charcoal barbecues outdoors. Observe the operating instructions
and regulations of the grill manufacturer.
 Keep this manual for future reference.
4. Overview
Refer to the illustrations on page 2 of this manual.
1 on-off switch
2 hot air nozzle
3 kick stand
4 ventilation openings
5 extension locking knob
5. Operation
5.1

Switching On and Off

1. Make sure the on-off switch is in the off position.
2. Plug the device to the mains.
3. Slide the on-off switch to the on position:
position I: 50 °C
o
position II: 600 °C
o
4. Switch the device to position I and let run for at least one minute before switching off.
5.2 Use as a Weed Burner
Nozzle Assembly
Slide the weed nozzle over the hot air nozzle.
Never touch the nozzle immediately after use. Risk of burn injuries!
Handle Assembly
Attach the handles on the device. The device may only be used with the handles attached.
Use
1. Switch on the device to position II. Allow the device to warm up for at least 45 seconds.
2. Hold the device at an angle of 45° away from the user.
3. Gently waft the nozzle approximately 5 seconds over the weed. Do not burn the plant completely, only the
heat is needed. Keep the nozzle at a distance of approximately 15 cm of the weed. Stronger weeds or
woody stems (wild grass, roots, etc.) may require a repeat application. If necessary, repeat this procedure
after a few days. Do not use this device on flower beds or lawns.
4. Switch off after use.
Notes
 Dry woods, leaves, pine needles and dry grasses may catch fire. Watch the treated plants for some time
after treatment.
 The best time to treat sprawl is in the spring. The results are not visible immediately.
 Older plants with hard leaves, such as thistles, dry earliest after repeated treatment at intervals of one to
two weeks. Some types of grasses are extremely robust and require a longer exposure to heat.
 The weed needs only be heated. Burning is not necessary. The cells of the leaves dry out in this way and
the weed dies.
 Certain weed species require repeated treatment.
V. 03 – 31/01/2018
VL102
6 extension
7 handle
8 lighter nozzle
9 power cord hook
WARNING
5 ©Velleman nv