Focon Showtechnic Expolite LED Fresnel 2K HD Bedienungsanleitung Seite 18

DERR: sets how the fixture responses if DMX-signal gets lost. Set SAVE to hold the last
received value or BLAK for blackout.
ZOOM: in this menu the minimum position (POS1), maximum position (POS2) and the home position
(BASE) of the motorised zoom are set, when controlling the zoom manually. This settings are limited
by the zoom settings made in the menu Zoom - Calibration.
PERF: gives the user the opportunity to change the performance of the fan between LIVE, STDO
and POWR. In STDO mode the fan is run on low noise. In case of overheat the intensity of the led
module is regulated down. In LIVE mode, fan speed and the intensity of the led module is balanced
with each other to reach the best output with as low fan speed as possible. In POWR mode the
temperature of the fixture is primary regulated by the fan, to keep a high intensity as long as possible.
MCON: sets if the fixture is a master and sends data to other fixtures (MAST), or not (SELF).
Zoom - Calibration
MENU
CAL
PERSON
In the calibration menu (CAL), submenu CALZ the general minimum (POS1) and maximum position
(POS2) of the motorised zoom can be set.
Current Software Version
When the software of the fixture is booting, the current installed software version is shown for about 5
seconds in the display.
HSIC CALZ
****
E-18
POS1
HSIC HSIC 0 - 255 SEND
****
POS2 HSIC HSIC 0 - 255 SEND
****