Focon Showtechnic Expolite LED Fresnel 2K HD Bedienungsanleitung Seite 16

Setting DMX-Address
MENU
PERSON ADDR
The DMX start address of the fixture is set in the menu ADDR. This is retained even when changing
the personality.
Setting DMX-Personality
MENU
PERSON SET
The personality is set in the menu SET, submenu PERS. There are three different modes which can
be choosen: UNO (1 channel), DOS (2 channels), STD.P (5 channels).
Editing Static Scene
MENU
STAT
PERSON
A static scene for stand-alone operation can be set in STAT. These are mixed using DIM and ZOOM.
Furthermore dimmer and zoom can also be controlled manually via the dim- and zoom-encoder
above the display. To use this function the appropriate encoder needs to be pushed twice. If
dmx-signal is pending the fixture switches back to dmx control after two minutes without using the
encoder.
Choosing Run Mode
MENU
RUN RUN
PERSON PERSON
The operating mode is set in menu RUN. For operation on a DMX-controller DMX needs to be
set. SLAV sets the fixture into slave mode.
Reseting Zoom-Motor
MENU
PERSON MOTR
In the menu MOTR the zoom-motor of the fixture can be reset (YES).
D.(001 - 512)
HSIC
HSIC PERS UNO
DOS
STD.P
HSIC DIM 0 - 100
0 - 100
ZOOM
DMX HSIC HSIC DMX
HSIC SLAV
HSIC YES
HSIC NO
E-16