Klarstein 10009110 Bedienungsanleitung Seite 24

• Press the button to select TIME, DISTANCE and CAL to preset.
MODE • Press the button for selection function display value on LCD, or enter after setting.
• Press the button and hold for 2 seconds to reset all value except Odometer to be zero.
To set up the target value of TIME, DISTANCE and CAL.
SET
Press the button and hold for 2 seconds to speed up the increment.
• Press the button to reset function value when setting.
• Press the button and hold for 2 seconds to reset all value except Odometer to be
RESET
zero. (When the user replace batteries, all the values will reset to ZERO automa-
tically.)
START/STOP: Zum Starten/Stoppen des Trainings
Please install 2 pieces of AA 1.5V batteries in the battery case on the back of
Batteries
monitor.(Whenever Batteries are removed, all the functions values will be reset
to zero.)
While the user starts to do exercise, the Display will show out the workout value
automatically. Once stop exercising over 256 sec, the Display will turn off. But
Auto On/Off
the workout value of odometer will be hold. While user starts exercise again,
workout value of odometer will accumulate continuously.
After the monitor is power on or press Mode key, the LCD will display all functions
Auto Scan values from Time-Calories-Odometer- Pulse- Speed- Distance. Each value will be
held for 6 seconds.
Speed Display the current training speed from 0.0 to 99.9 KPH or MPH.
Accumulates total distance from 0.0 up to 999.9. The user may preset target
time by pressing SET & MODE button. Each increment is 0.1 KM or M; each in-
Distance
crement will be 1 KM or M when distance is over 100. Automatically count down
from targeting value during exercise.
Accumulates total time from 00:00 up to 99:59. The user may preset target
Time
time by pressing SET & MODE button. Each increment is 1 minute. Automatically
count down from targeting value during exercise.
Console Operations
Function Buttons
Functions
24