Intended Use; Product Description; Nrgkick Connect Set Up - DiniTech NRGkick Connect Bedienungsanleitung

NRGkick Connect has a Bluetooth and WLAN radio system
integrated, which for safety reasons may not be brought into direct
body contact with heart pacemakers out of safety reasons.

4. Intended Use

NRGkick Connect may only be used to connect with NRGkick, Home
networks, Cloud and the NRGkick App. Section 5 describes operation
of the unit.
Any other use will be considered improper use. DiniTech GmbH does
not assume liability for any damage that results from such improper
use!
Intended use includes following the instructions in this manual as well
as observance of all labeling such as type plates, warning notices,
current limit marks, display symbols and ambient conditions.

5. Product Description

NRGkick Connect consists of a housing with a plug-in connection for
Schuko-Sockets. The plastic housing covers the internal electronics
with an integrated radio module.
EN
With NRGkick Connect you can integrate the NRGkick charging unit
into the WiFi, for unlimited flexibility and endless range. Control
your NRGkick conveniently via your smart devices. Start or stop the
charging process, limit the amount of energy to charge or display
information about the charging process like charged energy, energy
costs, CO2 savings and so on. Also included are advanced features
such as charging statistics analysis or photovoltaic-powered
charging, as well as access to the NRGkick cloud.
NRGkick Connect can only be used with NRGkick devices in the
version including Bluetooth.

5.1 NRGkick Connect set up

Inserting NRGkick Connect into the power supply starts the device.
The reboot is signaled slow flashes of the LED (2 seconds on, 2
seconds off).
After rebooting, the setup mode is started and indicated by a fast
flashing LED (0.3 second on, 0.3 second off).
During the setup mode NRGkick Connect communicates to the
NRGkick app via Bluetooth. The smartphone must be within a range
of about 10 meters of NRGkick Connect to make the set up.
To establish a working connection with NRGkick Connect, the
following five steps need to be implemented:
4 Ver.: 1810-01