Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Speaker connection
· Never connect the speaker cables with the chassis ground. This could destroy
your amplifier.
· Check that your speakers are connected correctly which means plus to plus and
minus to minus
We recommend speaker cable from 2.5 mm² and up. Other connection
variations are shown attached.
2. FUSE 40 A
This fuse protects the system for internal defects of the amplifier. If this
fuse burns out please check if the speaker cable ist connected correctly.
Never replace the fuse with a fuse with more ampere. Never bridge a fuse.
3. BATT+
Battery + (plus) terminal. The + (plus) 12 Volt power cable must be connected
with a fuse on the battery + (plus) terminal. We recommend a 100 ampere ANL
fuse and a copper cable with a thickness of 25 mm² for cable length up to 5
metres.
4. REM
Remote terminal. The remote cable must be connected with the radio automatic
antenna terminal so that the amplifier will switch on and off automatically with
the radio. If there are 2 or more amplifiers connected to this antenna terminal it
might be necessary to add an additional relay. Please consult your dealer.
5. GND
Chassis ground-terminal. The chassis ground cable must be connected very
tight on a nearby massive and electric conductive place.
6. PROTECT-LED
This LED lights up in case of any malfunction or internal damages. It also shows
if the amplifier is over-heat or low voltage protection as activated.
8
Werbung
