Control, Care And Inspection; Maintenance; Troubleshooting; Durati Battery-Powered Shearing Machine - B. Braun Aesculap DURATI Gebrauchsanweisung/Technische Beschreibung

Aesculap Suhl GmbH

DURATI battery-powered shearing machine

If necessary, repeat the cleaning/disinfecting pro-
cess.

5.2 Control, care and inspection

Allow the product to cool down to room tempera-
ture.
Inspect the product after each cleaning and disin-
fecting cycle to be sure it is clean, functional and
undamaged.
Lubricate the shearing head as appropriate, see
Lubricating the shearing head.
Check the product for any damage, atypical run-
ning noise, overheating or excessive vibration.
Inspect the shearing head for broken, damaged or
blunt cutting edges.
Set aside the product if it is damaged.
7.

Troubleshooting

7.1 DURATI battery-powered shearing machine
Issue
The DURATI battery-pow-
ered shearing machine
does not start
DURATI battery-powered
shearing machine has
come to a stop
DURATI battery-powered
shearing machine does not
load into the charging sta-
tion
10
Detection
Check switch position
–
–
–
–
LED indicators do not
light up
6.

Maintenance

To ensure reliable operation, Aesculap recommends
servicing the product at least once a year.
Service addresses
Albert Kerbl GmbH
Felizenzell 9
84428 Buchbach / Germany
Phone: +49 (0) 8086 933-100
Fax: +49 (0) 8086 933-500
Email: info@kerbl.com
www.kerbl.com
Other service addresses can be obtained from the
address indicated above.
Cause
Li-ion battery not loaded
Li-ion battery defect
Li-ion battery not
inserted
Li-ion battery deactivated
through protective circuit
Li-ion battery is empty
–
Remedy
Load Li-ion battery
Insert new Li-ion battery
Insert new Li-ion battery
Deactivate and reacti-
vate the control unit
Insert new Li-ion battery
see Charger and Li-ion
battery