Dry Vacuum Cleaning; Operation - Vetter MPS 2.0 MWF Bedienungsanleitung

Dry vacuum cleaning

Caution
Prior to dry vacuuming: Remove the dis-
posal pump and install the flat fold filter.
Note: You must use a flat fold filter during
dry vacuuming.
General
Caution
The flat pleated filter must always be in
place while vacuuming.
To vacuum fine dust, you can also use
–
an additional paper filter bag (optional).
Removal of the disposal pump
 Unplug the mains plug of the disposal
pump.
 Release and remove the suction head.
Illustration
 Unscrew the acorn nut of the disposal
pump.
 Remove the cable holder of the dispos-
al pump and replace it with a locking
cap.
 Remove the disposal pump and the
plastic insert from the container.
Illustration
 Install the locking cap instead of the dis-
posal hose.
 Insert and lock the suction head.
Installation of flat fold filter
Note: The flat fold filter is not included in
the delivery.
 Open filter door.
 Take out the coarse dirt filter.
 Install the flat fold filter.
 Close the filter door, it must lock into
place.
Install the brush strip
Illustration
 Remove the rubber lips.
 Install the brush strip.
14
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag (optional).
 Insert and lock the suction head.
Height adjustment of the floor nozzle
 Turn the adjustment screw in a clock-
wise direction: High position of the floor
nozzle
 Turn the adjustment screw in an anti-
clockwise direction: Low position of the
floor nozzle
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-40/C-DN-40 accessories can
be connected.
Danger
Risk of injury and damage! The socket out-
let is intended only for the direct connection
of the disposal pump. Any other use of the
socket outlet is not permitted.
Turning on the Appliance
 Plug in the mains plug of the appliance.
D
A
A Switch on button
B Switch off button/test key
C Circuit breaker
D Red indicator lamp
 Press the switch on button (the red indi-
cator lamp is ON). The protection
switch is now ready for operation.
– 3
EN

Operation

I
ON
O
TEST
B C