Device Elements; Start Up; Wet Vacuum Cleaning - Vetter MPS 2.0 MWF Bedienungsanleitung

Device elements

1 Float
2 Mains plug of the appliance
3 Power cord
4 Suction hose
5 Suction head lock
6 Dirt receptacle
7 Wheel
8 Cable holder of the disposal pump
9 Lock plate
10 Steering roller with fixed position brake
11 Floor nozzle
12 Height adjustment of the floor nozzle
13 Suction tube
14 Suction support
15 Suction head
16 Carrying handle
17 Filter cover
18 Push handle
19 Bender
20 Disposal pump
21 Acorn nut of the disposal pump
22 Float switch of the disposal pump
23 Mains plug of the disposal pump
24 Switch "Disposal pump OFF"
25 Socket
26 Switch "Disposal pump ON"
27 Main switch
28 Exhaust filter
29 Coarse dirt filter/flat fold filter
30 Closing cap (fire service C-coupling)
31 Nameplate

Start up

The appliance allows 3 operating modes:
1 Wet vacuuming with disposal pump
2 Wet vacuuming without disposal pump
3 Dry vacuum cleaning

Wet vacuum cleaning

Note: You can wet vacuum if the disposal
pump is turned off or has been removed.
Removal of disposal pump, see dry vacu-
uming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the paper filter bag
Illustration
 Release and remove the suction head.
 Pull the paper filter bag (optional) out
towards the rear.
 Insert and lock the suction head.
To suck wet dirt, first remove the paper
–
filter bag (optional).
Coarse dirt filter installation
 Open filter door.
 Take out the flat folded filter.
 Install the coarse dirt filter.
 Close the filter door, it must lock into
place.
Connection of disposal pump
Illustration
 Remove closing cap (fire service C-
coupling).
 Connect the disposal hose (nominal
width 3/4" or larger).
General
Caution
The coarse dirt filter must never be re-
moved during vacuuming.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
After the wet vacuuming: Clean the
–
floater, container and the disposal
pump if necessary, using a damp rag
and dry them.
– 2
EN 13