Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
JUMPSTARTER POWERBANK
FAQ:
Q1: What are the functions?
A: It supports charge for mobile, laptop, PSP, MP3/MP4 and other
digital devices, also light function with different modes. It can also
guarantee emergency start for autos.
Q2: How can LED emergency light be turned an?
A: Turn master switch of jump starter to "ON" and press power but-
ton for 3 seconds to start Iight. Then press power button shortly to
change the light modes and turn starter off.
Hold the key for three seconds to turn on LED lighting system.
Turn start power switch to "ON" if it is not used for long time turn
it to "OFF" to guarantee failure of power supply.
When not in use, turn off to avoid discharge and malfunction.
Q3: How long does it take for the jump starter
to be fully charged? And how to charge digi-
tal devices?
A: The device will be fully charged within 3 hours.
Keep the jump starter on the "ON" position, press the power button,
then you can charge mobile, tablet PC and other devices.
USB charge interface for mobile phone and tablet PC.
Turn start power switch to "ON".
Q4: How to start vehicle with jump starter
function?
A: Make sure the battery of jump starter is charged above 30%.
Then:
1. Connect jump cable to the drained battery of vehicle.
2. Connect red clamp to the positive"+" terminal and black clamp to
the negative "-" terminal.
3. Connect jump cable to the socket of jump starter.
4. Start the vehicle. If engine does not start in 30 seconds, wait at
least 1O seconds before attempting to start again.
5. Disconnect jump cable from the battery after the engine has been
successfully started.
LED display. The auto can be started when the quantity is 30% above.
Before start, turn start power supply switch ta "OFF".
Q5: HOW TO CHARGE THE DEVICE?
A: Use only the supplied AC home adapter or the DC car adapter to
charge the jump starter.
Put the plug of the charger into port 1 SV/1A, the other connect to
the 220V outlet or 12V car outlet, then turn on the switch.
Electric quantity LED display.
Q6: How to switch 19V, 16V and 12V outputs?
A: It has 19V, 16V and 12V outputs for you to choose.
Before turning on the main switch, short press it and you can switch
the output between 19V, 16V and 12V with light indicatars on. Dif-
ferent digital devices require different voltage. For example, laptop
may need 19V or 16V. So before use please confirm your required
voltage.
LED display the
Press the key shortly to
voltage.
Open silica gel/ plug and connect
storage battery Interfaces based
on corresponding positions.
Charge inlet.
Turn product switch to "ON".
switch voltage.
Turn product switch to "ON".
Werbung
