Sd Card Setting - Blaupunkt WiFi LampCam HOS-X20 Bedienungsanleitung

5. LampCam configuration
On the LampCam menu list tap the config LampCam icon and tap the settings icon from the desired
LampCam. Then tap the "Advanced" button to enter the "Advanced Settings Menu". For security reasons
you will be asked to enter the "Admin password".
5.1. Sensitivity Setting:
Scroll down to "Sensitivity Setting". At "Detect Mode" select "PIR" to activate PIR motion detection (factory
default setting). The PIR motion detection has a 5m detection range. To deactivate motion detection
select "OFF" .
5.2. Lighting Setting:
Scroll down to "Lighting Setting" and select the desired "Lighting auto mode".
By trigger: Select this option to turn the light ON for 1 minute after PIR motion detection. (Please check
in chapter 5.1. that PIR detection is activated) After one minute the light will turn OFF. (PIR needs to be
selected on "Sensitivity Settings"). Light will turn ON only if there is a low environment illumination.
By manual Schedule: Select this option to turn the light ON according to a pre-
configured schedule. To set up a schedule select "Lighting Schedule Modify".
Select a Starting time: Click the 00:00AM blue button at the top. At the top select
the days of the week to be included. Select the time when the light should be
turned ON. Time format is 12H, select AM or PM to define the time.
Select a Ending time: Click the 00:00AM black button at the bottom. At the
bottom select the days of the week to be included. Select the time when the light
should be turned OFF. Time format is 12H, select AM or PM to define the time.
Click the "Save" button at the bottom to save all the settings.
Note: It is mandatory to select the days of the week, otherwise the schedule wont work.
Note:
PIR trigger for motion detection and manual schedule will work only under AUTO mode. Refer to
chapter "6. Live View Functionalities" for more details.

5.3. SD Card Setting:

Click "Format SD-Card" to perform a SD-Card format. This will erase all the videos and images on the SD-
Card. If the "Over write SD-Card" check box is activated the LampCam will overwrite the oldest recording
once the storage is full. If deactivated the LampCam won't record any event once the storage is full.
5.4. Notifications:
Push notifications: Scroll down to "Notify Enable". Enable
/ Disable push notifications when movement is detected
under arm mode. (Enabled by default)
Email notifications: To enable the same information as push
notifications for e-mail, scroll down to "Email Setting" and
click "Set e-mail". Config according to the right hand chart.
Note: Ensure that "Two-factor authenticator" is disabled on
your sending e-mail account. (e.g. Google, Outlook365). To
learn more, check instructions from your e-mail provider.
SSL
Activate / deactivates SSL encryption
SMTP Server
Input the server SMTP address.
To learn more, check instructions
from your e-mail provider.
For Gmail use smtp.gmail.com
SMTP Port If SSL is not activated use "25"
If SSL is activated use "465"
Username
The user name of the sender email
account. E.g: username@gmail.com
Password
The password of sender email
account.
Receiver
Receiver email address
9