Charging The Battery - Walkercam S1 Bedienungsanleitung

CHARGING THE BATTERY

The S1 has an internal battery. You have to charge it before
use.
Anytime you are charging the device, make sure the
headphone jack is always fully dry. You can blow into the hole
and use a cotton tip or similar to fully dry the headphone jack
from water. This is important to avoid any charging and
shorting of any connections.
To charge the battery, the special USB cable is included in the
box. Simply connect the USB cable to the headphone jack (7.)
and a USB charger or a computer USB port. If using a
computer, make sure the computer switched on and not in a
sleep mode.
• Battery is charging: LED indicator light is RED. Charge the
battery for 2-3 hours to ensure maximum usage time.
• Battery is Full: LED indicator light will be BLUE. It is OK to
disconnect.
NOTE: To ensure that the player is charged correctly, connect
the USB cable directly in the USB connector of your PC (not in
a Hub).
If the battery is completely discharged, it's possible that the
device needs few minutes to start charging. Do not forget to
charge the device before the first use.
CONNECTION TO COMPUTER AND MUSIC UPLOAD
Connect the device to a computer with the USB cable. The
computer will automatically recognize the device. Once the
computer has detected the device, it will operate like a
memory stick. Music upload will be carried out in the same
way as with any other file transfer to storage device (for
2