Precautions For Use; Maintenance - Argo Allure Anleitung

A detailed diagram of the components is available on the last page.
1. Place the diffuser on a flat and stable surface and away from the edge.
2. Remove the diffuser's covers.
3. Pour mineral water (bottled or tap water) into the water tank up to the maximum level indicated (165 ml).
4. Then add a few drops of water soluble fragrance (3-6 drops) to the water tank.
5. Replace the covers on the diffuser.
6. Insert the adaptor's connector into the DC jack input at the back side of the diffuser.
7. Plug the adaptor into the outlet.
You are advised to change frequently the water in the tank and clean the diffuser once or twice a week, particularly if you
want to change the fragrance to be diffused.
1. Turn the appliance off and unplug it.
2. Remove the covers and pour the water into the tank. Empty the water using the water spout, located in the
opposite direction to the air outlet. Do not empty the water in the air outlet, this would damage the diffuser.
3. Clean the inside of the diffuser with a soft damp cloth and a little water. If needed, use a little white vinegar strongly
diluted. Do not use corrosive detergents. Carefully rub the ceramic disc with a cotton bud being careful about not to
scratch it.

PRECAUTIONS FOR USE

MAINTENANCE

6