Buffalo GH227 Bedienungsanleitung Seite 2

UK
Safety Tips

Position on a flat, stable surface

A service agent / qualified technician should carry out installation and any repairs if required.

Do not remove any components or service panels on this product

Consult Local and National standards to comply with the following:
o
Health and safety at work legislation
o
BS EN Codes of practice
o
Fire Precautions
o
IEE wiring regulations
o
Building regulations

DO NOT use jet / pressure washers to clean the appliance

DO NOT use the appliance outside

DO NOT use the appliance to store medical supplies

DO NOT use electrical appliances inside the appliance (e.g. heaters, ice-cream makers etc)

DO NOT allow oil or fat to come into contact with the plastic components. Clean immediately if contact occurs

DO NOT store products on top of the appliance

Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance

Always switch off and disconnect the power supply to the unit before cleaning

Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of local authorities

If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order
to avoid a hazard

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the
use of the appliance by a person responsible for their safety

Children should be supervised to ensure that they do not play with the appliance
Product Description
GH227 Buffalo 5.7L Cylindrical Soup Kettle
Pack Contents
Body Assembly
Top Ring
Installation
Remove all packaging and dispose of safely. Wash Liner, Top Ring and Lid in warm soapy water, rinse in clean water then dry
thoroughly.
Operation
Place the plug in the electric socket to connect electricity.
Partly fill the Body with water (water level should be between the Min and Max fill lines). Place the metal collar on the body of the
kettle, then place the inner liner inside the Body of the soup kettle (The inner liner should sit on top of the metal collar). Pour the
hot soup or food in to the Liner, then position the Lid on the Top Ring. Switch on electricity at socket. Start heating by rotating the
control knob clockwise, indicator light will come on and stay on until holding temperature selected is reached. Power will come on
to start heating again when the temperature of the kettle falls.
Kettle Liner
Lid Assembly