Heinner VCP001 Anleitung Seite 5

applications. Our warranty will be voided if the
machine is used in such purposes.
Technical data
Rated Power: 1500W
Voltage: 230V
Frequency: 50Hz
No Load Speed: 0-750rpm
Maximum Impact Rate: 4200bpm
Impact Energy: 5.5J
Maximum Chuck Capacity: 30mm
Copper motor
Cable length ~ 2m
Tool description
1 – SDS Plus chuck
2 – Mode selector switch (drill stop)
3 – Release button
4 – Oil gauge
5 – On/Off switch
6 – Mode selector switch (chisel stop)
7 – Variable speed
8 – Carbon brush holder
9 – Auxiliary handle
Before starting the equipment
Check the tool each time before you use it. If any
flaw is visible, take the tool to qualified personnel
to fix it. Do not open the tool.
Examine the surface you wish to work on to make
sure there are no hidden cables, gas or water
pipes.
Operation
Using the auxiliary handle is mandatory to have
maximum control over the tool.
If the drill gets blocked or caught, the safety clutch
is activated to prevent the tool from being
wrenched from your hands.
Drilling
Depress the release button 3 and rotate the mode
selector switch 2 to . Rotate the mode selector 6
switch to .
Hammer drilling
Depress the release button 3 and rotate the mode
selector switch 2 to . Rotate the mode selector 6
switch to .
Hammer function
Depress the release button 3 and rotate the mode
selector switch 2 to . Rotate the mode selector 6
switch to .
The mode selector knob may only be set when the
tool is switched off.
Before inserting the drill oil the end if it. To insert
it, twist the drill into its support until it engages.
Pull the tool to make sure it is locked correctly.
The tool does not have reverse direction,
so always take care not to force the chisel
in case the chisel bit gets stuck.
The chuck prevents the dust from getting into the
machine during its use. Make sure the chuck is not
damaged when changing the drills.
Do not put pressure on the tool while using it.
Light pressure gives best results.
When drilling there is a high pressure on the tool
and drills. Hold the hammer firmly to avoid losing
control.
Cleaning and maintenance
Make sure that the tool has come to a
complete stop and it is unplugged before
carrying out maintenance work.
Keep the case and cooling vents clean.
Oil feeding
Since an oil chamber is built in this electric
hammer, it can be used for approximately 20 days
without supplying lubrication oil (assuming that
the chisel is used continuously 3 –4 hours daily).
Check the oil level on a regular basis, confirming
that oil is filled.
When the chisel is held upright look through the
oil gauge window to see if oil is visible. If not, oil
must be poured into the container before
operating. If the tool is used without oil this could
seriously damage it and forfeit any warranty given.
When removing the oil gauge, be careful not to
lose the rubber packing attached below. After
feeding oil, securely clamp the oil gauge.
ROTARY HAMMER
4