Facom NS.3500G Original Bedienungsanleitung Seite 12

IMPORTANT SAFETY INSTRUCTIONS FOR ALL BATTERY CHARGERS
SAVE THESE INSTRUCTIONS: This manual contains important safety and operating instructions for battery chargers.
• Before using the charger, read all instructions and cautionary markings on the charger, battery pack and product using
the battery pack.
WARNING: Shock hazard. Do not allow any liquid to get inside the charger. Electric shock may result.
NOTICE: Under certain conditions, with the charger plugged into the power supply, the charger can be shorted by foreign
material. Foreign materials of a conductive nature, such as, but not limited to, grinding dust, metal chips, steel wool, alumi-
num foil or any buildup of metallic particles should be kept away from the charger cavities. Always unplug the charger from
the power supply when there is no battery pack in the cavity. Unplug the charger before attempting to clean.
VARIABLE SPEED TRIGGER
To turn the tool on, squeeze the trigger. To turn the tool off, release the trigger. The more you squeeze the trigger, the faster
the tool will operate.
FORWARD/REVERSE AND SPEED CONTROL
The forward/reverse and speed control switch (Fig. 1) determines the direction of the tool and also serves as the variable
speed control. To select full speed forward rotation, turn the switch to the far right side of the tool as shown.
To select reverse, turn the switch to the far left side of the tool as shown. Please note, reverse is always full power.
Forward rotation can be adjusted for variable speed by turning the lever between the three settings as shown in Fig 1, switch
will detent in each position.
LED LIGHT ACCESSORY
ATTENTION: LED light accessory must be charged before first use. LED light will not function until charged. LED light is
shipped in sleep mode, charging activates light function. (see charging section below)
Installation and Removal of LED Light
Removal: To remove LED light accessory from tool, rotate the LED light accessory counter clockwise, the LED light will
make a 'snap' noise as it rotates. At the top of the nose cone, the unlock symbol will line up with the hash mark when fully
unlocked. Pull the LED light accessory straight away from the tool to remove. Charging port is located on the back side of
LED light accessory (see charging section below).
Install: To install LED light accessory onto tool, line up the hash mark on top of the nose cone with the unlock symbol. Place
LED light accessory onto nose cone toward back of tool until it stops. THEN rotate clockwise, the LED light accessory will
make a 'snap' noise as it rotates and locks in place. The hash mark on top of the nose cone will now be lined up with the
lock symbol.
NU-NS.3500G-NS.3100G-NS.2500G_0118.indd 12
Fig. 1
Fig. 1
FORWARD - SPEED SETTING 1
FORWARD - SPEED SETTING 1
FORWARD - SPEED SETTING 3
FORWARD - SPEED SETTING 3
FORWARD - SPEED SETTING 2
FORWARD - SPEED SETTING 2
REVERSE
REVERSE
12
08/01/2018 08:10:25