Gitzo GHF2W Bedienungsanleitung Seite 10

FIG. 9 - If the equipment falls, find the balance point as follow.
1. FIG. 10 - Rotate and pull out the knob "H" to "off" position.
2. FIG. 11 - Rotate your equipment in the opposite direction of the fall.
3. FIG. 12 - Reach the first dash after the "zero" position accordingly to
the direction of the fall (always opposite direction) and rotate the knob
"H" to "ON" position until it locks into position.
4. FIG. 13 - Check if the equipment doesn't move: it means that you have
reached the balance point.
5. FIG. 14 - If the equipment falls down, repeat the instructions above,
selecting the following position (2nd and 3rd dashes after the ). 3rd
position allows the maximum balance capacity.
FIG. 15 – Remove equipment from the head
FIG. 16 – Use
N Pan control knob: friction and lock (360°)
F Tilt control knob: friction and lock (+90/-60°)