Intended Use; Before Use; Operation - GMC MS018 Bedienungsanleitung

Intended Use

Table mounted circular saw for cross, rip and mitre cutting of laminated
flooring materials.
Unpacking Your Tool
Carefully unpack and inspect your tool. Familiarise yourself with all its features
and functions.
Ensure that all parts of the tool are present and in good condition. If any parts
are missing or damaged, have such parts replaced before attempting to use
this tool.

Before Use

WARNING: Do not connect power until the tool
is assembled and configured correctly.
1. Attach the Feet (18) to the four corners of
the saw using the Feet Fixings (17)
supplied [Fig A]
2. Attach the Handle (15) to the Handle
Mounting Position (2) [Fig B]
3. Slide the Dust Bag (13) onto the Dust
Extraction Port (10) [Fig C]
Fig B
Notes:
• A vacuum can be connected to the dust extraction port instead of the dust
bag (this will provide superior extraction)
• Never operate the saw without either the dust bag or a vacuum connected
• Empty the dust bag every 10-15 minutes during use and at the end of every
session. The dust produced could be of a flammable nature and may contain
polyurethanes or linseed oil. Allowing the dust bag to get full will force the
dust back into the saw mechanism and it could ignite. Always follow the
manufacturer's recommendations for the materials being cut
The saw blade is pre-fitted but as part of the assembly process it is
recommended the user checks that the blade is securely tightened. Refer to
the 'Replacing the saw blade' section on how to access and tighten the blade
securing bolt.
Check the Throat Plate (6) is in good condition.
WARNING: The saw must not be operated if either side of the throat plate is
damaged or missing.
Fig A
Fig C
11
Installing The Saw
Position the saw on a solid, flat work surface. An anti-vibration rubber mat
can be placed between the saw and the work surface to reduce vibration and
prevent movement during use on some surfaces.
The saw can also be attached to a worktop or other surface by using extended
length bolts or screws than those supplied. In this instance the bolts would
pass through the worktop and the supplied feet before being screwed into the
aluminium frame of the saw. Alternatively the saw can be mounted on a longer
board that allows the saw to be clamped to a worktop with the clamps at a
position that will not interfere with the saw's operation. Securing the saw to a
worktop or other stable, strong surface will ensure maximum safety
during operation.
WARNING: Using this tool with a portable workbench can be dangerous.
Make sure there is no risk of the workbench collapsing or toppling during use.

Operation

Switching the unit on and off
• To switch the laminate saw ON, press the
green button marked ' I' on the On/Off
Switch (1). To switch the laminate saw OFF,
press the red button marked 'O' [Fig D]
IMPORTANT: Every time, before plugging
the laminate saw into mains power, press the
OFF button to check the saw will not switch on
immediately when plugged in
Making a rip cut
In this mode the saw cuts in a fixed position and the workpiece is moved in the
same way as a table saw.
1. Lock the saw in the rip position by securing the Rip Lock (3) in the Rip Lock
Fixing Point (4) [Fig E]
2. Set the Rip Fence (5) to the depth required for the cut and lock in position
[Fig F]
Fig E
3. Switch on the tool (see 'Switching the unit on and off') and allow the blade to
reach full speed
Fig D
Fig F
GB