Werbung
Notes
During
AssembIN
Use
a
soft platform below the parts to avoid scratches and damages.
Please
note you install the panels
with
the
UV
protected
side
out
(marked
with
"THIS
SIDE
OUT")
and peel the
film strip covering the
panels.
Product dimensions
can be
adjusted to your specific
needs:
1.The
wall-mounting profile (top-back)
can be
adjusted from 260
to
305 cm
(102.4"
to
120") above ground.
The
adjusting
is
done when measuring and
drilling
(Step
9).
Please
note the installation recommendations' height suggested
in
Diagram
A.
It
is
possible to fix the Patio Cover back wall
height
at the lowest
point of
260
cm/102.4".
This
method
is
optional if the
assembly
conditions
and
exterior walls
do
not allow to follow the suggested installation
as
appears
in
the manual.
Please
note
that
the product appearance may slightly change
as
a
result,
however snow
load
weight
does
not
change.
2. Poles
distance from the wall
can be
adjusted from 226
to
286 cm (89"
to
112.5")
as
suggested
in
Diagram
B1.
Poles
distance from the
side edges can be
adjusted from
0
to
54 cm
(0"
to
21.3")
as
suggested
in
Diagram
B2.
The
adjusting
is
done after assembly and before anchoring (Step 25) by sliding poles and profile
7031+7030
at the
roof
profiles' channels.
3. Wall
mounting
and distance from the wall
determine the roof angle and the total depth of the product
(distance
of
gutter from the
wall). Higher wall
mounting
and shorter distance between wall and poles increase the
roof
angle and
shorten the total depth
as
suggested
in
Diagram
C.
j
Steps
Step
7: Please
apply silicone
sealants on
both
sides
of
the part combining 8119
in
order to prevent water
leakage.
Step 8: Apply silicone
sealants on
the inner part
of 8116 & 8117
and
connect to the profile.
Step 16: Apply silicone sealants above beam 7288 +7289,
in
order to prevent water from seeping
in.
Step
18: Make sure
that the angle between the
back wall profile and the panel
supporting
profiles
is
90
degrees.
Step
20:
Please
note you install the panels
with
the
UV
protected
side
out
(marked
with
"THIS
SIDE
OUT") and
peel
the film strip covering the
panels.
Step
25:
Please
adjust the
poles (inside
out
and sideways) by sliding
them to their final position prior to
anchoring.
Make sure
that
the poles distance from the
Patio cover side
edge does not
exceed
54
cm/21.3':
Step 26: Anchoring this product to the ground
is
essential to its
stability
and
rigidity.
It
is
required to complete
this stage
in
order for your warranty to
be
valid.
*Tighten
all screws
when completing
assembly.
Note:
The
wall anchoring kit supplied with this
product
is
suitable only for concrete
walls.
Other wall types
need
an
accordant wall fixation
kit.
II
260-305cm
102.4"-120"
B1
226-286cm
89"-
112.5"
13°
-13
17°
Werbung
