Battery Replacement And Disposal - Summit X670-G2 Serie Installation

Battery Replacement and Disposal

Never look at the transmit LED/laser through a magnifying device while the laser is powered on.
●
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are
●
powered on.
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the
●
beam when optical connections are unplugged.
Never alter, modify, or change an optical device in any way other than suggested in this
●
document.
Battery Replacement and Disposal
Batteries included with Extreme products are encapsulated and must be replaced only by qualified
Extreme Service personnel. Contact your Extreme Networks Service personnel for product replacement.
Do not attempt to replace the battery. If these instructions are disregarded and replacement of these
batteries is attempted, the following guidelines must be followed to avoid danger of explosion:
Replace with the same or equivalent battery type as recommended by the battery manufacturer.
●
Dispose of the battery in accordance with the battery manufacturer's recommendation.
●
Battery Warning — Taiwan
WARNING!
Disconnect Device Requirement
WARNING!
A readily accessible disconnect device shall be incorporated in the building installation wiring.
Un dispositif de déconnexion facilement accessible doit être incorporé dans l'installation électrique du bâtiment.
6
Summit X670-G2 Series Switches Installation Note