Summit X670-G2 Serie Installation

17300 Summit X670-G2-72x
17300T SummitX670-G2-72x
Summit X670-G2 Series Switches
Installation Note
Pre-installation Requirements
Before you install the Summit X670-G2 series switch, read the information in
page 2.
The following items are provide with the Summit X670 series switch:
Mounting brackets
●
Eight M3 screws to secure the mounting brackets to the switch
●
To install the switch in a rack, you need the following additional tools and equipment:
Four rack mounting screws to match your equipment rack
●
Screwdriver to fit the rack mounting screws
●
AC power cord that is suitable for the current rating of this product (See
●
Supply Cords" on page
Required Tools
The following items are provided with the Summit X670-G2 series switch:
Two rack mounting brackets adaptable for either a front-mount or mid-mount installation
●
Twelve screws for attaching the brackets to the switch enclosure
●
For DC models, spade terminal and M4 screw with captive washer for grounding the switch
●
You need the following additional tools and materials to install the switch in a rack:
#1 Phillips screwdriver
●
Four rack mounting screws to match your equipment rack
●
Screwdriver to fit the rack mounting screws
●
#14 AWG stranded copper cable for grounding the switch (DC powered models)
●
ESD-preventive wrist strap for installing optional ports at the back of the switch
●
Part Number: 120845-00 Rev. 01
4.
"Safety Information" on
"Selecting AC Power
1