Omnitronic KVP-101 Bedienungsanleitung Seite 20

14. MIC1-SOCKET (XLR)
15. MIC2-SOCKET (XLR)
16. Optical-output
17. Y-output
5. INSTALLATION
(1) Install the audio/video-player on a plane surface or in your rack.
(2) Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
(3) Remove the protection foil from the display.
(4) Please note that the LC-display can only be read from an angle of 45° to the top and of 5° to the bottom.
(5) Rack-installation: This audio/video-player is built for 19" racks (483 mm). The rack you use should be a
Double-Door-Rack where you can open the front panel and the rear panel. The rack should be provided
with a cooling fan. When mounting the audio/video-player into the rack, please make sure that there is
enough space around the device so that the heated air can be passed on. Steady overheating will
damage your device. You can fix the audio/video-player with four screws M6 in the rack. Be aware that
fastening the device with four screws on the front panel is not enough. In order to ensure safety,
additional fastening by using ground and side bars is necessary.
(6) CAUTION: Make sure that the audio/video-player is switched off (power-switch in outer position) before
you connect it to the mains in order to avoid damages on your loudspeakers.
5.1. Connection
a) Connect your TV-set via an RCA-cable to the audio/video-player (VIDEO-socket).
b) Connect your TV-set via an AV-RCA-cable (yellow, red, white) or via an S-video-cable to the audio/video-
player.
18. Pb/Cb-output
19. Pr/Cr-output
20. Composite-output
21. Cinch L-output
22. Cinch R-output
20/27
23. Coaxial-output
24. S-Video-output
25. AC CONNECTION
Plug in the power supply cable
here.
00030092.DOC, Version 1.0