Fenix W - MAT Gebrauchs- Und Montageanweisung Seite 8

Procedure for testing the residual current device:
a) Look for the test and reset buttons on the residual current device.
b) Connect the supply lead to the electrical socket. Press the RESET button - the indicator
light will light up.
c) Press the TEST button - the indicator light will go out.
d) Press the RESET button – the indicator light will light up once again.
e) If the indicator light doesn't light up, check if the socket has power.
f) If the socket has power, but the residual current device still won't work, contact FENIX
Slovakia.
g) It is necessary to test the RESET button before use.
7. Cleaning the rubber mat
The heated rubber mat requires cleaning after use. Typical widely-available floor-cleaning
products can be used. Dip a cloth into the solution made with the cleaning product and wash
the surface of the heated rubber mat, removing all dirt.
Do not use diluting agents or solvent strippers to clean the mat.
Approximate surface temperature of a W-mat heating mat in a stabilized state after
approximately one hour of operation.
*achieved temperatures may vary depending on the composition of the structure under the W-MAT
heating mat. In order to increase the start-up speed and possibly achieve higher surface
temperatures, suitable thermal insulation (e.g. F-BOARD) can be laid under the W-MAT heating
mat.
Warranty conditions
The supplier provides a 24-month guarantee on the product, valid from the date of sale. The warranty
does not extend to damage caused during transport, by careless handling or by inexpert installation.
The warranty also does not cover everyday wear and tear on the product. Any alterations to the
product are considered a violation of the warranty conditions. The complete warranty conditions can
be found on the web pages www.fenix.eu.
Fenix Slovensko s.r.o.
Iliašska cesta 86 974 05 Banská Bystrica
tel: +421 48 414 32 53 fax: +421 48 414 32 52
email: fenix@fenix.sk, http://www.fenix.sk
Room
temperature temperature W-
[°C] MAT* [°C]
5
11
14
16
tel.: +420 584 495 304, fax: +420 584 495 303
fenix@fenixgroup.cz , http://www.fenixgroup.cz
Surface
16
23
27
30
Fenix Trading s.r.o.
Slezská 2, 790 01 Jeseník
8