Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
similarly qualified person in order to avoid a hazard.
•
This appliance is not intended for use by persons (including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliances by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
The appliance is not a toy. Do not let the children play it. Never let children insert foreign objects
into the appliance.
•
Do not use the appliance for other than intended use. This appliance has been designed solely for
domestic use; the manufacturer's liability shall not be engaged in the event of any professional
use, by any misuse or by any use not complying with the operating instructions.
•
Save these instructions.
•
The Device should only be connected to the protective contacting socket which is grounded.
•
It should be placed on a solid place completely and horizontally.
•
It is not suitable to install in any place where the current-carrying part of the socket possibly lies
in water when it rains.
•
If the socket is installed near any kind water basin, the distance must at least maintain at 0.5
meter
•
Only when using sockets made according to the same protective type, the device can fully reach
the IP44 function.
•
If you want to move the socket to other places, make sure the socket is separated from electricity
during that.
General Instructions
•
This kind of socket can be reconnected. But before open the socket box, make sure the power
supply is halted.
•
When changing the connecting wire, please use the following type of wire: H07RN-F 3G1.5mm2.
The length of the wire is at least 1.4 meters.
•
Please connect correctly the green/yellow grounding safety lead wire to the connecting location
with grounding safety lead wire mark.
•
Do it as possible as you can to guide current-conducting lead wire to the binding post and connect
it. Grounding safety lead wire should be 8 mm longer than required.
•
Lead wire must be connected firmly to the binding post and all the lead wires should be inside the
binding post.
•
You must install correctly the india rubber packing and O-encircling wire which can prevent spray
and then screw up the fixed screw and catch screw socket according to the rule. Only through this,
it can prevent spray.
Setting the timer
Use the internal time switch to activate or respectively deactivate the device automatically at desired
times.
•
First set the current time by turning the timer ring clockwise until the arrow and current hour of
the day are corresponding.
•
Every hour has 4 small marks indicating every 15minutes with little levers attached that can be
switched with a small screwdriver or similar.
•
Outwardly switch any 15-minutes-lever of the period you want the device to activate. For example
if you push the switch over 10:15h, the device will be active from 10:15h until 10:30h.
•
The timer wheel turns around completely within 24 hours.
•
It stops turning when you disconnect the device from power supply. After connecting again you
will have to set the timer again.
•
•
•
•
•
5
Installation and Usage
Werbung
Inhaltsverzeichnis
