Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fax +32 2 359 95 50
Fill the water tank (variable steam dial on
Put the plug of the appliance into the power socket.
Turn the temperature dial clockwise into the required position.
Turn variable steam dial to the
larger amount of steam.
Set the iron on its heel and wait until the temperature indicator goes out.
Caution: Set the temperature dial within the steam range. If temperature setting is too low,
water may drip from soleplate.
Check the garment label before ironing because some cloths may be damaged when
exposed to steam or water.
SPRAY
Produces a mist for removing stubborn creases.
Spray
can be used at any temperature setting and during either dry or steam pressing.
Press down the spray button to spray.
BURST OF STEAM
The burst of steam feature
CARE AND CLEANING
Cleaning the inside parts of the iron is done by turning the steam dial into the
position and holding the iron horizontally for about one minute so steam can escape.
When you turn the variable steam dial into the
take it out.
There is no problem. YOU JUST HAVE TO PUT IT BACK IN ITS PROPER PLACE BEFORE EACH
USE. Therefore just keep it deep (in the good position) and turn it clockwise.
Caution, this cleaning function allows you to remove some scale particles but it does not
replace a full descaling.
To clean the plastic parts of the iron, use a humid cloth.
To clean the soleplate, make sure you use a product made especially for this purpose.
Never use abrasive products.
WHEN YOU HAVE FINISHED IRONING
Turn temperature dial to "MIN" and unplug iron from electrical outlet.
With soleplate facing away from you, turn iron upside down to empty water.
Then store the hot iron on its heel rest so that any remaining moisture will evaporate.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
position).
position for minimum steam or to the
provides additional steam for removing stubborn creases.
, this goes up a little bit and you can
9
Assembly page 9/28
position for a
Werbung
Inhaltsverzeichnis
