Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mobile phone/power supply/RF relation(reference value)
10 cm
Peak power
20 cm
Peak power
30 cm
Peak power
50 cm
Peak power
7.
DC voltage measurement: switch the (9) into „TEST VOLTAGE", connect the load
into terminals (7) and (8), display (4) will show the DC voltage value of the connec-
ted load. Max value which can be measured is 200V DC.
8.
If some problems occur when turning on the device, check the fuse place at the
back side of the device. If the fuse is blown, please replace it with the same type fuse
(the same current and voltage parameters).
BEFORE FIRST USE
Upon receipt of the goods, check the packaging for integrity and open it. If the
packaging is damaged, please contact your transport company and distributor within 3
days, and document the damages as detailed as possible. Do not turn the package upsi-
de down! When transporting the package, please ensure that it is kept horizontal and
stable. Please keep all packaging materials (cardboard, plastic tapes and styrofoam), so
that in case of a problem, the device can be sent back to the service centre in accurate
condition.
Disposing of packaging
The various items used for packaging (cardboard, plastic straps, polyurethane foam)
should be conserved, so that the device can be sent back to the service center in best
conditions in case of problem!
INSTALLING THE APPLIANCE
Appliance location
The work surface where the device will be located must be suitable for the size of the
appliance, please refer to the measurements. The work surface must be levelled, dry,
heat-resistant and at a fitting height from the ground to enable a proper use of the
device.
The power cord connected to the appliance must be properly grounded and corre-
spond to the technical details.
REGULAR CLEANING
Generalities
•
Never clean the device with a pressurized water-jet, industrial cleaners, and brus-
hes or any other type of cleaning utensil that could damage the surface of the
appliance.
•
Before cleaning you must remove the electricity supply plug isolating the appliance
from the main power circuit.
10
EN
DE
40 cm
35 cm
25 cm
20 cm
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case,
please contact your customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
•
Invoice number and serial number (the latest is to be found on the technical pla-
te on the device).
•
If relevant, a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determinate the source of the
problem if you make a detailed and precise description of the matter.
The more detailed your information, the quicker the customer service will be able to
answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer ser-
vice. This can lead to a loss of warranty!
EN
11
Werbung
Inhaltsverzeichnis
