Jata calor RD225 Bedienungsanleitung Seite 11

• Do not use the appliance near the showers, bath, washbasin or
swimming pools.
• Do not dampen it nor immerse in water or any other liquid.
• Do not place under plugs.
• Don't allow children play with the appliance. Keep the appliance
out of the reach of children.
• To unplug, pull from the plug, never from the cable.
• Do not place near the curtains, flammable items or products.
• Always place the heater in vertical position.
• Do not rest the cable on hot parts of the appliance.
• This device has a built-in security system that interrupts
operation in case of overheating. If this happens, unplug and
wait about 30 minutes before connecting again.
• The cleaning and maintenance done by users, can not be done by
children without any supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
LEGS ASSEMBLING
• The legs (5) must be assembled at the end of the lower part of the appliance.
• Match the holes of the legs with the axes located in the lower part, then screw them.
INSTRUCTIONS OF USE
• Unwind totally the cord from the cord storage.
• Plug in the appliance to the mains.
• Turn the thermostat knob (3) clockwise to the maximum position (MAX).
• Place the power selector (2) in the desired position. Doing this operation the indicator (4) will light on. Have in
mind that:
- Position I: minimum power.
- Position II: maximum power.
- Position 0: off.
• Once the room reached the desired temperature, turn the thermostat knob (3) anti-clockwise until the pilot
light (4) goes off. Leave the knob in that position and the thermostat automatically maintains at the selected
temperature.
"NO-FROST" FUNCTION
• Being the thermostat knob (3) in anti frost position (*) and the power selector (2) activated, the radiator switches
on automatically when the temperature of environment falls bellow 5 °C.
MAINTENANCE AND CLEANING
• Before you clean the appliance, ensure the appliance is unplugged.
• Allow the hot parts to cool.
• It is important to keep the air intake and output grids clean of dust and fluff.
• Clean with a soft dry cloth.
01 manual jata RD225 - RD232.indd 11
11
19/05/16 09:43