Water Container; Condenser - Iberna Gea IDC60 Gebrauchsanleitung

05651919English.qxd
ENGLISH

Water Container

The water removed from the laundry
during the drying cycle is collected in a
container at the bottom of the dryer.
When the container is full the EMPTY
WATER indicator (
panel will light and the container MUST
be emptied.
Note: Very little water will collect during
the first few cycles of a new machine as an
internal reservoir is filled first.
We recommend that the container be
emptied after each drying cycle.
To empty the water container:
1. ENSURE THE MACHINE IS
SWITCHED OFF. Gently pull the
bottom of the kickplate so that it
unclips from the dryer. The top section
can then be unhinged allowing the
kickplate to be completely removed
(fig. 5).
2. Pull firmly on the drawer front
handgrip and slide the water container
out of the dryer (fig. 6). Support the
container with both hands. When full,
the water container will weigh about
4 kg (fig. 7).
3. Open the lid located on the top of the
container and empty the water (fig. 8).
4. Refit the lid and slide the water
container back into position. PUSH
FIRMLY IN PLACE.
10
14/09/2004 11:38 Page 12
) on the control

Condenser

IMPORTANT: Always switch off and
remove the plug from the electricity
supply before cleaning the condenser.
To maintain the efficiency of the dryer
regularly check that the condenser is
clean.
To remove the condenser:
1. Remove the kickplate (fig. 5).
2. Turn the two locking levers anti-
clockwise (fig. 9).
3. Pull out the condenser unit (fig. 10).
4. Gently remove any dust or fluff with a
cloth, then wash the unit by holding it
under a running tap (fig. 11) turning it
so that water flows between the plates,
to remove any dust or fluff.
5. Refit the condenser ensuring it is
pushed firmly into place. Lock the two
levers by turning them clockwise.
6. Refit the kickplate.