Installing Your Oliscan Scanner; Mounting The Scanner Supports - Olivetti OLISCAN A600 Bedienungsanleitung

Installing your Oliscan Scanner

NOTE: Refer to the section "Principal safety regulations" on page IV to
be sure that you perform the installation correctly and with due
regard to safety.

Mounting the scanner supports

The scanner can only be used with a special type of support. Do not use different
supports to those supplied by the manufacturer.
1. Turn the scanner carefully upside down
2. On the underside, towards the Rear connector, insert the two anchoring
hooks into the gaps on the bottom, and push the support in the direction
indicated by the arrow below, until it locks into place.
3. Perform the same operation for the second support.
4. Return the unit to its upright position to start operating.
6
OLISCAN A600 - USER'S GUIDE